AIRTRONICS M12 Podręcznik Użytkownika Pobierz pdf (Strona 91)



Adjust the Offset value to move the vertical axis and erase the Trim deviation from the Master Travel Indicator. If there is no

Trim deviation displayed, you can simply position the starting point of your Mix by choosing the desired Offset value.











When the Master and Slave are set to the same channel, Mixing takes place within the channel itself. This causes servo

travel to Increase for Positive Rate percentage values and servo travel to Decrease for Negative Rate percentage values.

Changing the Rate 1 and Rate 2 Percentage Values:

The Rate percentage values determine the amount and direction of Slave channel servo travel. Use a Positive or Negative

percentage value to change the amount and direction of Slave channel servo travel. The Right side of the graph indicates Rate 1

percentage values and the Left side of the graph indicates Rate 2 percentage values.

1) From within the C-MIX1 menu, scroll UP or DOWN to highlight either RATE1

> 0% or RATE2 > 0%.

2) Press the ENTER key, then scroll UP or DOWN to choose the desired Rate 1

or Rate 2 percentage value.

RATE1 and RATE2 setting range is -150% to 150% . The default setting for both

Rate percentage values is 0%.

WARNING: The Rate percentage values can be set Higher than your Slave channel servo End Points (up to 150% in either

direction). To avoid damage to your Model, we don't suggest programming Rate percentage values that exceed your Slave

channel servo End Points.

Changing the Channel Offset Value:

The Offset function allows you to shift the Neutral Point of the Slave channel servo to compensate for any Master channel servo

Trim or to change the starting point of your Mix.

1) With the Master channel control centered, check the Master Travel Indicator

at the bottom of the graph to see if any Master channel Trim is displayed.

2) From within the C-MIX1 menu, scroll UP or DOWN to highlight OFFSET > 0.

3) Press the ENTER key, then scroll UP or DOWN to choose the desired Slave

channel Offset value. Increase or Decrease the Offset value to move the

vertical axis in the desired direction.

OFFSET setting range is -150 to 150 . The default setting is 0%.

Following the example in the diagram at Right, set the Rate 1 percentage value to

0% and the Rate 2 percentage value to -50%, then set the Offset value to -100. The

full range of Mixing travel can now be adjusted in one direction when turning the

Auxiliary Dial counter-clockwise.

This same technique can also be used if you're using the Auxiliary Lever to

control either Auxiliary 1 or Auxiliary 2.

When the Auxiliary Dial is programmed to control Auxiliary 1 or Auxiliary 2 and you choose AUX1 or AUX 2 (or

#AUX1 or #AUX2) to be the Master channel, by setting the Offset value to 100 or -100, the Auxiliary Dial can

control the full range of Mixing travel in one direction, instead of half the Mixing travel in one direction and half the

Mixing travel in the other direction. This is useful if you want the full range of Mixing travel in only one direction.

Setting the Offset value to a value greater than -100 or 100 will shift the Neutral Point of the Slave channel

servo beyond the operation range of the Auxiliary Dial and is not recommended.

0MAX

Auxiliary

Dial

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 115 116

Komentarze do niniejszej Instrukcji

Brak uwag

AIRTRONICS M12 Podręcznik Użytkownika Strona 91

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Zdalne sterowanie AIRTRONICS M12