AIRTRONICS M12 Podręcznik Użytkownika Pobierz pdf (Strona 83)













Choosing the Channel, Continued....

2) Press the ENTER key to open the SPEED menu. The < ST > channel will be

Selected.

3) Press the SELECT switch RIGHT or LEFT to choose the desired channel you

would like to program the Servo Speed function for.

Changing the Servo Speed Forward Value:

1) From within the SPEED menu, scroll UP or DOWN to highlight FORWARD > 0.

2) Press the ENTER key, then scroll UP or DOWN to choose the desired Servo

Speed Forward value. When 0 is Selected, the servo will travel at its normal

speed in the Forward direction. When a Negative value is Selected, the servo

transit speed will slow down in the Forward direction.

FORWARD setting range is 0 to -100. The default setting is 0 (Normal Speed).

Changing the Servo Speed Return Value:

1) From within the SPEED menu, scroll UP or DOWN to highlight RETURN > 0.

2) Press the ENTER key, then scroll UP or DOWN to choose the desired Servo

Speed Return value. When 0 is Selected, the servo will travel at its normal

speed in the Return to Neutral direction. When a Negative value is Selected,

the servo transit speed will slow down in the Return to Neutral direction.

RETURN setting range is 0 to -100. The default setting is 0 (Normal Speed).

When the Throttle channel is Selected, you are able to adjust Servo Speed function Programming Values separately for both

the Throttle High Side (H) and the Throttle Brake Side (B).

1) From within the SPEED menu, scroll UP or DOWN to highlight POINT > 100%.

2) Press the ENTER key, then scroll UP or DOWN to choose the desired Point

percentage value.

POINT setting range is 5% to 100%. The default setting is 100%.

Changing the Point Percentage and IN and OUT Values:

The Point percentage value determines where along either side of servo travel that the servo's transit speed will be changed. The

IN and OUT values determine whether the change in servo transit speed occurs between the two points (IN) or outside the two

Points (OUT). See the diagram on the previous page.

If a 100% Point percentage value is chosen, the servo's transit speed will be the same along the entire length of travel. IN

and OUT values are only discernible if a Point percentage value other than 100% is chosen.

3) Press the ENTER key, then scroll DOWN to highlight IN/OUT > IN.

4) Press the ENTER key, then scroll UP or DOWN to choose the desired IN/OUT

value, either IN or OUT.

IN/OUT setting range is IN or OUT. The default setting is IN.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 115 116

Brak uwag

AIRTRONICS M12 Podręcznik Użytkownika Strona 83